Install Your New Phone (7800 Series)

Document created by Cisco Localization Team on Dec 15, 2016Last modified by Cisco Localization Team on Jan 19, 2017
Version 3Show Document
  • View in full screen mode
  

Your phone comes with everything you need to power it up, connect it to the network, and set it up on your desk.

You cannot adjust the Cisco IP Phone 7811 footstand.

If you'd like to see a graphic overview of these steps, see the Cisco IP Phone 7800 Series Installation Guide.

       
1    Plug the long, straight end of the handset cable into the phone and plug the other end into the handset.
2    Connect the network cable from your network to the network port on the phone.
3    Connect the footstand and adjust the angle of the phone.
  1. Insert the curved connectors into the lower slots.   
  2. Lift the footstand until the connectors snap into the upper slots.     

    You may need to exert more force than you expect to connect or disconnect the footstand.

         
  3. Adjust the angle of the phone.
4    Plug in the external power supply.
 


Attachments

    Outcomes