Your selfview shows what others see from your Board, Desk, or Room Series device in a call. You can use it to confirm that they see what you want them to see.

You may want to have your selfview activated during the meeting to ensure that you remain seen on the screen.

If you find the current position of the selfview blocks important parts of the image on your screen, you can move it around.

To check your selfview at any time, swipe from the right side of your device's home screen, or tap the button. As long as your camera is open/on, you'll see your selfview in the control panel.

Tap the eye icon and:

  • Toggle on Full screen if you want to see your selfview in full. To exit full screen, open the control panel and toggle off Full screen.

  • Toggle on Show selfview if you want to see your selfview. To hide your selfview, toggle it off.

To close the control panel, tap anywhere else on the screen.


If you have your selfview in fullscreen mode in a call, you can see the other participants on the top of the screen.

To open and change the location of your selfview on the screen during a call:

  1. If it's not already visible, tap the screen to open the selfview up on top of the call.

  2. Press the selfview and drag and drop it to change the location. It will snap to pre-defined locations as you drag.

To check your selfview at any time, tap the button on the controller's home screen. As long as your camera is open/on, you'll see your selfview on the device's screen. Tap Camera on the controller and then select Selfview. Here, you can:

  • Toggle Full screen on and off.

  • Toggle Show selfview on and off.

  • Adjust the selfview position by tapping any of the predefined positions shown on the touch controller screen.


If you have your selfview in fullscreen mode in a call, you can see the other participants on the top of the screen.

To open and change the location of your selfview on the screen during a call:

  1. Tap the arrow at the bottom of the controller's home screen to get the call controls. Tap Selfview.

  2. You get the same options as above, to set visibility, move, or change your selfview to full screen. Tap outside the camera options screen to return to the call controls.

1

Tap the Selfview icon. You can now see your selfview on the screen.

2

To close the selfview, tap the Selfview icon again.

1

Tap the Camera icon and select Selfview. You can now see your selfview on the screen.



2

Use the camera settings to pan, tilt, and zoom the camera position to get the camera view you want.

Tap the Maximize and Minimize icon to toggle between the PiP image and full-screen image.

3

When you're in a call you can change the location of your self-view on your screen.


In the call menu on the Touch 10, press the selfview icon and drag and drop it to change the location. You can select between six predefined locations.

4

To close the selfview, tap the Camera icon and deselect Selfview.

1

Navigate to the camera icon in the upper right corner on the home screen and select it with the remote control’s OK button.


2

Select Pin Selfview icon to turn selfview on. Select the Minimize/Maximize icon to toggle between PiP and full screen self-view.


Select the camera icon in the Camera Control menu to get access to the zoom control and the pan and tilt wheel. Use these to adjust the camera position.



3

To close the selfview, go to the Camera control menu and deselect Pin Selfview.