These devices support briefing room: Codec Pro, SX80, Room 70 G2, MX700, MX800, and MX800 Dual.

A briefing room is equipped with three screens and two cameras, as shown in the following example setup.

The briefing room is tailored around three room modes: local presenter, remote presenter, and discussion mode. It is easy to change the mode on-the-fly, so that it suits the type of training you are delivering.

  • Local presenter: The presenter is in the room.

  • Remote presenter: The presenter is calling in.

  • Discussion: For discussions between different sites, and with a local presenter in the room.

Change room mode during a meeting

Your administrator may or may not have set up the room to switch between the local presenter and remote presenter modes automatically. If automatic switching is not enabled, use the touch controller to switch between room modes manually.

Automatic switching implies:

  • Local presenter mode is used when a presenter is detected on the local stage.

  • Remote presenter mode is used when no presenter is detected on the local stage.

Always use the touch controller to choose discussion mode.

Switch between room modes manually

1

Tap Briefing Room on the touch controller.

2

Tap the mode that you want to change to: Local Presenter, Remote Presenter, or Discussion. The current mode is highlighted.


 
If your administrator hasn't disabled automatic switching, the room mode will continue to change according to the automatic switching rules listed above.