Use the following procedure to add an authenticated proxy or new proxies after onboarding.


  • The supported proxy authentication schemes are Basic and Digest.

  • You can add only one proxy at a time.

Before you begin

Ensure that you have installed the Agent COP file on the node.

1

Log in to the Unified CM or IM and Presence node using the admin CLI.

2

Check the proxy list using the following CLI command:

admin:utils ucmgmt proxy list

3

Add a new proxy using the following CLI command:

admin:utils ucmgmt proxy add http://<host>:<port> [username]


 

  • Perform this step on all nodes in the cluster.

  • If you're adding an authenticated proxy, provide the username and password in the previously mentioned command.

For example, admin:utils ucmgmt proxy add http://proxy.dummy.com:80 abc

The following is a sample output.

Successfully contacted controller.
{
"serviceName" : "HCSAC",
"serviceType" : "REQUIRED",
"serviceState" : "online",
"message" : "Healthy",
"lastUpdated" : "2020-08-04T15:34:52.931Z",
"upstreamServices" : [

{ "serviceName" : "RDS", "serviceType" : "REQUIRED", "serviceState" : "online", "message" : "Healthy", "lastUpdated" : "2020-08-04T15:34:45.476Z", "upstreamServices" : [ ] }
]
}
4

Disable the telemetry service on each node. For more information, see Start and Stop the Telemetry Service section in Set Up Cisco Webex Cloud-Connected UC for On-Premises Devices.


 

If you're onboarding a node for the first time, skip this step.

5

Check if the proxy list now has http://<host>:<port> added.

admin:utils ucmgmt proxy list

6

After you have completed the preceding steps, restart the service on the Control Hub so that the telemetry module selects the new proxy information.


 

If you're onboarding a node for the first time, skip this step.

What to do next

For information about how to onboard CCUC on-premises devices, see Set Up Cisco Webex Cloud-Connected UC for On-Premises Devices.