Use the Cisco Headset USB HD Adapter

Your Cisco Headset 730 comes with a USB adapter for use with call devices that don't have a Bluetooth option. The USB HD Adapter comes out of the box pre-paired to your headset. The adapter automatically connects to your headset when it plugs into a powered USB port.

When you want to disconnect your headset, simply unplug the adapter from the call device. It takes about 10 minutes for your headset to accept another active Bluetooth connection after you disconnect the USB HD Adapter. You can also turn off your headset then on again to pair a new device quickly.

USB Adapter

You can't install firmware updates to your headset through the USB HD Adapter.

1

Plug in your USB HD Adapter to your preferred device.

2

Turn on your Cisco Headset 730.

3

Select Cisco HS USB Adapter from your Bluetooth device list.

Pair the USB HD Adapter to Your Headset

You can re-pair your USB HD Adapter if you have erased your headset's Bluetooth pairings or need to replace your adapter.

1

Connect the USB HD Adapter to your chosen device.

2

Use a pen or a paper clip to press down the Pairing button on the USB HD Adapter for four seconds. The blue LED on top of the adapter blinks when it enters pairing mode.

USB HD Adapter button
3

On your headset, slide and hold the Power/Bluetooth switch for two seconds. The adapter and your headset pair automatically.