The Briefing Room setup is designed for easy use of rooms where you deliver training and education sessions. The setup helps bringing together groups from different sites. Whether the presenter is in the room or calling in from a remote location, participants receive a good and engaging experience.
A Briefing Room is equipped with three screens and two cameras, as shown in the following example setup.
The Briefing Room is tailored around three room modes: Local Presenter, Remote Presenter, and Discussion mode. It is easy to change the mode on-the-fly, so that it suits the type of training you are delivering.
Local Presenter (the presenter is in the room).
Remote Presenter (the presenter is calling in).
Discussion (for discussions between different sites with a local presenter in the room).
Change Room Mode During a Conference
Your administrator may or may not have set up the room to switch between the Local Presenter and Remote Presenter modes automatically. If the automatic switching is not enabled, you must use the Touch 10 controller to change between room modes.
Automatic switching implies:
Local Presenter mode is used when a presenter is detected on the local stage.
Remote Presenter mode is used when no presenter is detected on the local stage.
If you want to use the Discussion mode, you always have to use the Touch 10 controller to choose it manually.
Switch between the different room modes using the Touch 10 controller
Tap Briefing Room on the Touch 10 controller.
Tap the mode that you want to change to: Local Presenter, Remote Presenter, or Discussion. The current mode is highlighted.