Follow these steps to enable Cloud Connected PSTN. For more information, see:

  1. Provision Location(s) in Control Hub.

  2. Select Cloud Connected PSTN as the connection type for the location(s) and select the corresponding CCP provider(s).Select Cloud Connected PSTN Select the corresponding Provider for each Location
  3. Order PSTN numbers from a CCP provider (integrated or non-integrated). Integrated providers will supply numbers directly to Control Hub, where they will appear automatically. For non-integrated providers, import the PSTN numbers as follows:

    1. Sign into Control Hub and go to Calling > Numbers menu. Click the Manage drop down menu on the right side of the table and select Add.Select Manage > Add

    2. Select the Location from the drop-down menu on the selection page. The PSTN connection associated with the location is listed against the location. Select the Location and note the corresponding PSTN connection

    3. Add the PSTN numbers purchased in the fields on the Select Numbers page. You may add up to 1000 numbers and choose to activate them immediately or later. Click Save after all numbers have been added.Add the purchased PSTN numbers

    4. The confirmation page displays the PSTN numbers that have been added to the location.Confirmation of added PSTN numbers

  4. Perform the following steps for each Location to create a Route List, assign it to an appropriate Route Group, and select which numbers will be assigned to DI.

    1. Navigate to Calling > Route Lists and choose one from the list to view its properties.

    2. Select a Route Group from the Routing Choice menu.

    3. Click Add Numbers and enter the numbers associated with the Route List.Add numbers to the Route List

    4. Select the PSTN numbers in the Route List that are designated for Dedicated Instance (in/out) and click Add.Identify which numbers are designated for DI

    As part of Dedicated Instance service activation, SIP Trunks to Dedicated Instance and the Route Groups are created in Control Hub (the name starts with “WxC-DI”).
  5. Configure Dial Plans in Webex Calling with patterns pointing to Dedicated Instance and associate it with a Route Group.

  6. Configure Dedicated Instance:

    • Configure the PSTN DIDs and assign them to phones, users, hunt pilot, etc.

    • Configure dial plan on Dedicated Instance to route PSTN calls to Webex Calling, using the Route Group, Route List, and SIP trunks configured during Dedicated Instance service activation.

  7. To enable international calling, select the relevant location in the Control Hub > Calling page. Navigate to the Advanced > Outgoing and Incoming Permissions > Outgoing Calls > International section and select Allow from the drop-down menu.


  • The Calling Number in the SIP INVITE from DI must match the E164 number configured in the Webex calling route list for the call to succeed.

  • Review the Audio specifications for Webex Calling documentation for supported/preferred audio codec by Webex Calling. This must be considered for the design of Dedicated Instance for CCPP calls.