The Webex Room Navigator for wall mounting can be configured as a room booking device. It displays the room availability status and users can book impromptu meetings or see the room calendar.
To access the startup wizard for a previously configured Room Navigator, perform a factory reset. Long-press the name in the upper left corner of the touch controller screen to get this option.
To configure the Webex Room Navigator for room booking, go through the startup wizard.
Pair the touch controller to the room device as described in Connect Touch Controller to a Room Device or Webex Board Over the Network (LAN).
Set the Device type to Room Booking.
Select whether the Room Navigator is located inside or outside a room.
This completes your Room Navigator setup. You might still need to set up the room device for booking. See Enable Room Booking For Shared Mode Webex Rooms for details.
You might need to perform a factory reset in order to pair the Room Navigator with a different room device or to configure it as a controller.
When the Room Navigator is in Room Booking mode, find the factory reset option by pressing and holding (5-6 seconds) on the room name in the upper-left corner of the screen.
When you tap Factory Reset, you'll be asked to confirm your selection before the Room Navigator is restored to factory settings.